Today, in my craft room I created this beautiful card. I spend more time thinking about what I am going to create than on what I actually create.Below I have included some pictures and I will attempt to tell you how I made this card through pictures.
I used a 5" x 7" card base for this card. I cut a piece of patterned cardstock 4" x 6 3/8". I cut about 1/2" off the front flat of the card (what is going to be the bottom of the front). I then cut another coordinating piece of cardstock 1" x 7" and attached it to the bottom of the front flap.
I then inked the entire edges of the card base with SU Strawberry Slush ink. I masked over the detail on the bottom of the front with post it notes to protect it from getting ink on it..
I then completely covered the patterned cardstock with wide "tulle like" ribbon. I completely covered the front of the cardstock with glue stick and adhered the ribbon. I glued the ends on the back with snail.
I then cut a piece of SU Strawberry Slush ruffled ribbon 6 3/8" and adhered it near the bottom of the front.
I then inked a 3 1/2" paper doily with SU Strawberry Slush Ink.
I then cut a paint color chart 1' x 8 1/2" and fringed the edge. I made sure not to cut right through. You can see in the picture below how I did this. I then ran snail runner along the length of the paint chart where I did not cut through (this will keep the roll in place). I then started rolling from the lightest end, making sure to keep the roll tight.
Then I started pulling the fringes down to flatten out to make a flower. I inked the edges of the "petals" with SU Strawberry Slush and stuck pink pearls in the center.
Lastly I assembled the card together and used embellishments to finish off the card. Here is a close up look at the "tulle like" ribbon on the card and the finish it gives the card.